- Interface between Ethernet IP Network and Power Supply
- IP-address can be configured by user,
make use of existing networks
- 16-bit accuracy for voltage and current programming or output monitoring
- Read-back of status signals, change power supply modes like: Remote/Local
- Digital user in- and outputs (isolated)
- Software Calibration
- SCPI commands
- Internal Card available for ES150, ES300, SM800, SM1500, SM3000, SM6000
Note: internal interface cards are factory fitted and calibrated, see datasheet for ordering details.
- External module for other power supplies
- Free software for "Sequence building", "Scope wave simulation" and "Simple control" ,
for details see Software-datasheet
- Download PDF-datasheet
- Download Software
Integrated Sequencer
- Power supply generates arbitrary waveforms, stored in sequencer
- Waveform generation independent of computer, stand-alone possible
- Very fast or slow sequences: time between steps from 1 ms till hours
- 25 free programmable sequences each with 2000 steps
- Simulation of Battery voltage at engine start, Surges, Generators, etc.
